Custom Eyelet — Iron with Die-Casting
We supply eyelet to garment factories and brands, built in Iron with die-casting for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is washer bite, so the eyelet does not pull out of the cloth, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Eyelet |
|---|---|
| Inner diameter | 6 mm |
| Type | self-piercing eyelet |
| Base material | Iron |
| Finish / process | Die-Casting |
| Colour options | 24 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 1000 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | SNI or SIRIM documentation per destination; EN 71 part 3 for decorative components |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Hard Enamel Fill — available on Iron, quoted per position and per colour.
- Rose Gold Plating — available on Iron, quoted per position and per colour.
- Chrome Plating — available on Iron, quoted per position and per colour.
- Epoxy Dome — available on Iron, quoted per position and per colour.
- Stamping — available on Iron, quoted per position and per colour.
- Black Oxide — available on Iron, quoted per position and per colour.
- Injection Moulding — available on Iron, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed inner diameter
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with die-casting applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same washer bite.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Start your eyelet programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
