Custom Eyelet — Polycarbonate with Gold Plating
We supply eyelet to garment factories and brands, built in Polycarbonate with gold plating for denim and workwear programmes. On a trim like this the specification that decides the outcome is setting tooling tolerance, which decides whether the line runs clean, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Eyelet |
|---|---|
| Inner diameter | 5 mm |
| Type | two-part eyelet and washer |
| Base material | Polycarbonate |
| Finish / process | Gold Plating |
| Colour options | 16 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 500 pieces per style per finish |
| Sampling | 12 working days, 4 days per revision |
| Bulk lead time | 25-40 days after approval |
| Compliance | GSO conformity with Arabic labelling; REACH nickel-release test for metal findings |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Powder Coating — available on Polycarbonate, quoted per position and per colour.
- Sewn Edge — available on Polycarbonate, quoted per position and per colour.
- Paint Spray — available on Polycarbonate, quoted per position and per colour.
- Die-Casting — available on Polycarbonate, quoted per position and per colour.
- Chrome Plating — available on Polycarbonate, quoted per position and per colour.
- Overlocked Edge — available on Polycarbonate, quoted per position and per colour.
- Rubber Coating — available on Polycarbonate, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed inner diameter
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with gold plating applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same setting tooling tolerance.
FAQ
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How long does sampling take?
A first sample takes 12 working days, and each revision about 4 days.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Start your eyelet programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
