Custom Eyelet — Acrylic with Injection Moulding
We supply eyelet to garment factories and brands, built in Acrylic with injection moulding for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is setting tooling tolerance, which decides whether the line runs clean, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Eyelet |
|---|---|
| Inner diameter | 8 mm |
| Type | two-part eyelet and washer |
| Base material | Acrylic |
| Finish / process | Injection Moulding |
| Colour options | 24 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 2000 pieces per style per finish |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | GSO conformity with Arabic labelling; salt spray test for metal finishes |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Powder Coating — available on Acrylic, quoted per position and per colour.
- Rubber Coating — available on Acrylic, quoted per position and per colour.
- Mirror Polish — available on Acrylic, quoted per position and per colour.
- Soft Enamel Fill — available on Acrylic, quoted per position and per colour.
- Hard Enamel Fill — available on Acrylic, quoted per position and per colour.
- Antique Brass Plating — available on Acrylic, quoted per position and per colour.
- Anti-Rust Treatment — available on Acrylic, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed inner diameter
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same setting tooling tolerance.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How long does sampling take?
A first sample takes 7 working days, and each revision about 3 days.
Which compliance documents do you provide?
We prepare salt spray test for metal finishes and the supporting test reports for the destination market.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Start your eyelet programme
Tell us the quantity, the target price and the delivery window — we will tell you what is realistic before you commit.
