Custom Rhinestone in Polypropylene (PP) with Anti-Rust Treatment for Outerwear and Jacket Programmes

Custom Rhinestone — Polypropylene (PP) with Anti-Rust Treatment

We supply rhinestone to garment factories and brands, built in Polypropylene (PP) with anti-rust treatment for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is wash durability of the setting, measured in cycles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.

The failures here are predictable: packing that arrives mixed and unusable on the line, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Sewn Edge — available on Polypropylene (PP), quoted per position and per colour.
• Soft Enamel Fill — available on Polypropylene (PP), quoted per position and per colour.
• Pantone Colour Matching — available on Polypropylene (PP), quoted per position and per colour.
• Rubber Coating — available on Polypropylene (PP), quoted per position and per colour.
• Rose Gold Plating — available on Polypropylene (PP), quoted per position and per colour.
• Mirror Polish — available on Polypropylene (PP), quoted per position and per colour.
• Hard Enamel Fill — available on Polypropylene (PP), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed size
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with anti-rust treatment applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same wash durability of the setting.

FAQ

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Which compliance documents do you provide?

We prepare salt spray test for metal finishes and the supporting test reports for the destination market.

Start your rhinestone programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.