Custom Zipper — ABS Plastic with Hard Enamel Fill
We supply zipper to garment factories and brands, built in ABS Plastic with hard enamel fill for uniform and corporate programmes. On a trim like this the specification that decides the outcome is slider smoothness across the full length, tested by hand on bulk, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: packing that arrives mixed and unusable on the line, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare UKCA and REACH documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Zipper |
|---|---|
| Gauge | #3 |
| Type | invisible zipper |
| Base material | ABS Plastic |
| Finish / process | Hard Enamel Fill |
| Colour options | 12 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 500 pieces per style per finish |
| Sampling | 10 working days, 4 days per revision |
| Bulk lead time | 25-50 days after approval |
| Compliance | UKCA and REACH documentation; REACH nickel-release test for metal findings |
| Ship to | Felixstowe (the United Kingdom) |
What buyers can customise
- Soft Enamel Fill — available on ABS Plastic, quoted per position and per colour.
- Heat-Cut Edge — available on ABS Plastic, quoted per position and per colour.
- Epoxy Dome — available on ABS Plastic, quoted per position and per colour.
- Offset Printing — available on ABS Plastic, quoted per position and per colour.
- Overlocked Edge — available on ABS Plastic, quoted per position and per colour.
- Rose Gold Plating — available on ABS Plastic, quoted per position and per colour.
- Heat Transfer Printing — available on ABS Plastic, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed gauge
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with hard enamel fill applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same slider smoothness across the full length.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
How long does sampling take?
A first sample takes 10 working days, and each revision about 4 days.
What is the minimum order?
Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.
Start your zipper programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
