Custom Zipper in Polycarbonate with Heat Transfer Printing for Denim and Workwear Programmes

Custom Zipper — Polycarbonate with Heat Transfer Printing

We supply zipper to garment factories and brands, built in Polycarbonate with heat transfer printing for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is pull strength of the slider and the stop, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• UV Printing — available on Polycarbonate, quoted per position and per colour.
• Injection Moulding — available on Polycarbonate, quoted per position and per colour.
• Ultrasonic Welding — available on Polycarbonate, quoted per position and per colour.
• Overlocked Edge — available on Polycarbonate, quoted per position and per colour.
• Soft Enamel Fill — available on Polycarbonate, quoted per position and per colour.
• Offset Printing — available on Polycarbonate, quoted per position and per colour.
• Heat-Cut Edge — available on Polycarbonate, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed gauge
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with heat transfer printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for OEKO-TEX Standard 100 for dyes and trims are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same pull strength of the slider and the stop.

FAQ

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

Start your zipper programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.