Custom Zipper in Polycarbonate with Offset Printing for Outerwear and Jacket Programmes

Custom Zipper — Polycarbonate with Offset Printing

We supply zipper to garment factories and brands, built in Polycarbonate with offset printing for uniform and corporate programmes. On a trim like this the specification that decides the outcome is slider smoothness across the full length, tested by hand on bulk, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: a supplier who disappears once the deposit is paid, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Pleating — available on Polycarbonate, quoted per position and per colour.
• Nickel Plating — available on Polycarbonate, quoted per position and per colour.
• Overlocked Edge — available on Polycarbonate, quoted per position and per colour.
• Crochet — available on Polycarbonate, quoted per position and per colour.
• Heat Transfer Printing — available on Polycarbonate, quoted per position and per colour.
• Anti-Rust Treatment — available on Polycarbonate, quoted per position and per colour.
• Dye-Sublimation Printing — available on Polycarbonate, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed gauge
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with offset printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same slider smoothness across the full length.

FAQ

Which compliance documents do you provide?

We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

What is the minimum order?

Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Start your zipper programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.