Custom Zipper in Polypropylene (PP) with Heat-Cut Edge for Uniform and Corporate Programmes

Custom Zipper — Polypropylene (PP) with Heat-Cut Edge

We supply zipper to garment factories and brands, built in Polypropylene (PP) with heat-cut edge for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is tape shrinkage matched to the garment fabric, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: a supplier who disappears once the deposit is paid, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Offset Printing — available on Polypropylene (PP), quoted per position and per colour.
• Heat-Cut Edge — available on Polypropylene (PP), quoted per position and per colour.
• Gold Plating — available on Polypropylene (PP), quoted per position and per colour.
• Antique Brass Plating — available on Polypropylene (PP), quoted per position and per colour.
• Overlocked Edge — available on Polypropylene (PP), quoted per position and per colour.
• Digital Printing — available on Polypropylene (PP), quoted per position and per colour.
• Soft Enamel Fill — available on Polypropylene (PP), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed gauge
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with heat-cut edge applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for OEKO-TEX Standard 100 for dyes and trims are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same tape shrinkage matched to the garment fabric.

FAQ

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

Which compliance documents do you provide?

We prepare OEKO-TEX Standard 100 for dyes and trims and the supporting test reports for the destination market.

How long does sampling take?

A first sample takes 10 working days, and each revision about 4 days.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

Start your zipper programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.