Custom Zipper in Stainless Steel with Offset Printing for Uniform and Corporate Programmes

Custom Zipper — Stainless Steel with Offset Printing

We supply zipper to garment factories and brands, built in Stainless Steel with offset printing for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is tape shrinkage matched to the garment fabric, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: a finish that tarnishes or rubs off after washing, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Paint Spray — available on Stainless Steel, quoted per position and per colour.
• Soft Enamel Fill — available on Stainless Steel, quoted per position and per colour.
• Pleating — available on Stainless Steel, quoted per position and per colour.
• Hot Foil Stamping — available on Stainless Steel, quoted per position and per colour.
• Embossing — available on Stainless Steel, quoted per position and per colour.
• Sewn Edge — available on Stainless Steel, quoted per position and per colour.
• Chrome Plating — available on Stainless Steel, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed gauge
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with offset printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same tape shrinkage matched to the garment fabric.

FAQ

How long does sampling take?

A first sample takes 7 working days, and each revision about 4 days.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

Which compliance documents do you provide?

We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.

Start your zipper programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.