Custom Zipper in Stainless Steel with Epoxy Dome for Denim and Workwear Programmes

Custom Zipper — Stainless Steel with Epoxy Dome

We supply zipper to garment factories and brands, built in Stainless Steel with epoxy dome for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is slider smoothness across the full length, tested by hand on bulk, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: packing that arrives mixed and unusable on the line, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Embroidery — available on Stainless Steel, quoted per position and per colour.
• Hard Enamel Fill — available on Stainless Steel, quoted per position and per colour.
• Rose Gold Plating — available on Stainless Steel, quoted per position and per colour.
• Powder Coating — available on Stainless Steel, quoted per position and per colour.
• Injection Moulding — available on Stainless Steel, quoted per position and per colour.
• Paint Spray — available on Stainless Steel, quoted per position and per colour.
• Antique Brass Plating — available on Stainless Steel, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed gauge
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with epoxy dome applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same slider smoothness across the full length.

FAQ

What is the minimum order?

Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.

Which compliance documents do you provide?

We prepare colour fastness to washing, rubbing and light and the supporting test reports for the destination market.

How long does sampling take?

A first sample takes 14 working days, and each revision about 3 days.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

Start your zipper programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.