Custom Garment Label — EVA Foam with Powder Coating
We supply garment label to garment factories and brands, built in EVA Foam with powder coating for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is edge softness, since scratchy labels are the first complaint, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Garment Label |
|---|---|
| Size | 30 x 70 mm |
| Type | satin printed label |
| Base material | EVA Foam |
| Finish / process | Powder Coating |
| Colour options | 8 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 2000 pieces per style per finish |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; EN 71 part 3 for decorative components |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Piece Dyeing — available on EVA Foam, quoted per position and per colour.
- Rubber Coating — available on EVA Foam, quoted per position and per colour.
- Heat Transfer Printing — available on EVA Foam, quoted per position and per colour.
- Pleating — available on EVA Foam, quoted per position and per colour.
- Crochet — available on EVA Foam, quoted per position and per colour.
- UV Printing — available on EVA Foam, quoted per position and per colour.
- Dye-Sublimation Printing — available on EVA Foam, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with powder coating applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same edge softness.
FAQ
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 14 working days, and each revision about 3 days.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your garment label programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
