Custom Garment Label in Polyethylene (PE) with Sewn Edge for Bridal and Eveningwear Studios

Custom Garment Label — Polyethylene (PE) with Sewn Edge

We supply garment label to garment factories and brands, built in Polyethylene (PE) with sewn edge for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is edge softness, since scratchy labels are the first complaint, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: minimum order quantities far above what a growing brand can absorb, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Rubber Coating — available on Polyethylene (PE), quoted per position and per colour.
• Paint Spray — available on Polyethylene (PE), quoted per position and per colour.
• Dye-Sublimation Printing — available on Polyethylene (PE), quoted per position and per colour.
• Screen Printing — available on Polyethylene (PE), quoted per position and per colour.
• UV Printing — available on Polyethylene (PE), quoted per position and per colour.
• Heat Transfer Printing — available on Polyethylene (PE), quoted per position and per colour.
• Yarn Dyeing — available on Polyethylene (PE), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed size
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with sewn edge applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same edge softness.

FAQ

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

Which compliance documents do you provide?

We prepare salt spray test for metal finishes and the supporting test reports for the destination market.

Start your garment label programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.