Case Study: Custom Toggle Button for a Car Interior Supplier in Morocco

Toggle Button for a Car Interior Supplier in Morocco

A Car Interior Supplier approached us with a toggle button requirement for the Morocco market. The brief was specific: a defined look, a hard launch date and a unit cost that had to survive freight and duty. This case study records what was specified, what went wrong in sampling and how the bulk order was delivered.

The challenge

• A compliance document that arrived after the goods were already shipped
• A trim that passed sampling but failed in-line because it was never cycle tested
• A zipper puller that broke under pull test at the warehouse

What we specified

How it was resolved

1. We rebuilt the specification around Silicone and locked the tolerance before bulk.
2. The finish was moved to Glossy Enamel Coating after strike-off tests showed better durability.
3. A pre-production sample was approved and retained as the golden reference.
4. Production ran with in-line inspection and a mid-run photo report.
5. Cartons were packed to the client's own barcode and ratio specification.

Result

• 10,000 pieces delivered inside the 6-week window.
• Unit cost held within 1.5% of the original quotation.
• Inspection-related rejection stayed under 2.0%.
• The specification is now on file, so reorders reproduce the approved sample.

What we would repeat

Approve a pre-production sample made from the actual bulk base material. Substitute material behaves differently in finishing.

Planning something similar?

If you are comparing suppliers, send us the spec they quoted against. We will quote the same spec and show you where the difference sits.