Case Study: Custom Digital Print Fabric for a Hat and Cap Producer in Chile

Digital Print Fabric for a Hat and Cap Producer in Chile

A Hat and Cap Producer approached us with a digital print fabric requirement for the Chile market. The brief was specific: a defined look, a hard launch date and a unit cost that had to survive freight and duty. This case study records what was specified, what went wrong in sampling and how the bulk order was delivered.

The challenge

• Lead time quoted without the plating or dyeing sub-process
• A zipper puller that broke under pull test at the warehouse
• Cartons packed to the factory ratio instead of the buyer's size ratio

What we specified

How it was resolved

1. We rebuilt the specification around Nylon and locked the tolerance before bulk.
2. The finish was moved to Powder Coating after strike-off tests showed better durability.
3. A pre-production sample was approved and retained as the golden reference.
4. Production ran with in-line inspection and a mid-run photo report.
5. Cartons were packed to the client's own barcode and ratio specification.

Result

• 20,000 pieces delivered inside the 4-week window.
• Unit cost held within 4.5% of the original quotation.
• Inspection-related rejection stayed under 1.0%.
• The specification is now on file, so reorders reproduce the approved sample.

What we would repeat

Approve a pre-production sample made from the actual bulk base material. Substitute material behaves differently in finishing.

Planning something similar?

If you are comparing suppliers, send us the spec they quoted against. We will quote the same spec and show you where the difference sits.